Filter
Top Products
rails are assembled properly into the PC Card Header. The rail goes
under the edge of the header. Tighten the header screws from the bottom
of the system board.
Removing the PC Card (PCMCIA) Rails
NOTE: The rails for the 400 and 410 models are not interchangeable with
the rails for the 420 and 430 models.
To remove the PC Card rails, follow these steps.
1. Remove the PC Card clips. Refer to "Removing the PC Card Clip" in this
section.
2. Slide the rails out of the header (Figure 3-61).
3. To replace the PC Card rails, reverse the previous steps. The PC Card
rails go under the edge of the Header.
Cha
p
ter 3.17 PC Card
(
PCMCIA
)
E
j
ection Levers and Pin