Filter
Top Products
8 517212-001 — Removing and Replacing the Hard Disk Drive
4 Place the drive so the guide screws fit into the guide
screw slots. The drive manufacturer’s label should be
visible when the drive is in place.
5 Push the hard drive back into the bay and then to the
right until it locks. When the drive is properly located,
the threaded holes in the drive line up with the holes
in the drive bay, and the power and data cables will
route properly.
6 Replace the hard drive retention screws and tighten
them.
7 Reconnect the power cable and data cable to the
optical disc drive.
NOTE: The location of the cable connections may
vary with the optical drive model in your computer.