Filter
Top Products
3.
Remove the two Phillips PM2.5×5.0 screws that secure the top cover to the computer.
4. Disconnect the caps lock LED board cable (1) from the system board.
5. Release the ZIF connector to which the TouchPad cable (2) is connected, and then disconnect the
TouchPad cable from the system board.
6. Remove the Phillips PM2.5×9.0 screw (3) that secures the top cover to the base enclosure.
7. Lift the rear edge of the top cover (1), and then swing it up and forward until it rests at an angle.
56 Chapter 4 Removal and replacement procedures