Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-2 User Interface
Writer: Fran Spragens Project: User Interface Comments:
File Name:3324_3.doc Last Saved On:3/16/99 3:05 PM
User Access
There are two modes of access to the user interface: READ-ONLY and
READ/WRITE. READ-ONLY access allows you to view switch information,
but not modify any operating parameters. READ/WRITE access allows you to
both read and modify switch information. You are required to login with a
password before obtaining READ/WRITE access. The factory default password
is “public” (lower case), allowing full READ/WRITE access until a new
password is set.
To use the console menus, do the following:
1. Type the letter associated with the desired option.
If the selected item is a submenu title, the submenu is displayed when you
enter the letter.
2. Enter the parameter requested by the screen prompt.
If the selected item is a parameter, the system displays a prompt for the
entry of a new parameter value. If the value entered is invalid, a beep
sounds, or a message displays, requesting you to enter a valid value.
Factory Defaults
Table 3-1 lists the factory default settings for the switch configuration
parameters. Each of these parameters can be changed via the console menus or
Telnet.