Filter
Top Products
www.powerleap.com • www.friendtech.com
-6-
Installation Guid
e
Upgrading Your Computer’s BIOS
Some motherboards may require a BIOS upgrade in order to work with the latest Pentium III and Celeron CPUs. For
information about getting a BIOS upgrade for your computer system, start by visiting the brand-name manufacturer’s web site.
Do this with your original CPU installed in the motherboard. BIOS upgrades may be downloaded from the system vendor or the
motherboard maker’s website(s). If you can’t find BIOS upgrade information there, try the following:
Many brand-name computer manufacturers use OEM motherboards. Check the motherboard maker's ID, then go to their site to
look for a BIOS upgrade. Look for upgrades at the sites of your motherboard’s original BIOS manufacturer: AMI
(www.amibios.com
), Award (www.award.com), MR BIOS (www.mrbios.com), and Phoenix (www.ptltd.com) produce popular
BIOS software.
Wim’s BIOS Page (www.wimsbios.com
) discusses BIOS flashing in detail, and so do Lost Circuits
(www.lostcircuits.com/advice/bios.html
) and FlashBIOS (www.flashbios.org/). The BIOS Setup Information Guide
(www.matrix-bios.nl/frames.html
), Tom’s Hardware BIOS Guide (www.tomshardware.com/bios.html), and the BIOS
Optimization Guide (http://www.rojakpot.com/bog.aspx) also offer a wealth of BIOS information.
Important! When installing the latest BIOS for your system, be sure to follow the BIOS upgrade instructions carefully.
Visit our online technical support area at www.powerleap.com/support.
Manual v1.0, March 2003. Copyright 2002-2003 PowerLeap Products, Inc. All Rights Reserved.
PowerLeap is a registered trademark of PowerLeap Products Inc. PL-P3/SMP is a trademark of PowerLeap Products Inc. Intel, MMX, and
Pentium are registered trademarks of Intel Corporation. Other product names mentioned herein are used for identification purposes only and
may be trademarks and/or registered trademarks of their respective companies.
The information in this document is subject to change without prior notice in order to improve reliability, design and function and does not
represent a commitment on the part of the manufacturer.