Filter
Top Products
Reverse the above procedure to install the IrDA board.
Chapter 7.15 Speaker Assemblies
The bottom cover assembly must be removed before removing the speaker
assemblies. The speaker assemblies are installed as a unit with their
cables permanently attached.
To remove the speaker assemblies, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 7.3.
2. Remove the bottom cover assembly as described in Section 7.5.
3. Note the cable routing and disconnect the speaker cables from the
connector board (Figure 7-31).
4. Remove the four screws from the speaker mounting brackets and lift the
speaker out of the bottom cover assembly (Figure 7-31).