Filter
Top Products
Removal and Replacement Procedures
Compaq ProLiant ML350 Generation 3 Server Maintenance and Service Guide 2-21
COMPAQ CONFIDENTIAL Codename: Steel Dragon 2.4 Part Number: 278704-002 Last Saved On: 12/18/02 9:43 AM
Hot-Plug Hard Drive
NOTE: The server does not need to be powered off to complete this operation.
To remove a hot-plug hard drive:
1. Open the bezel door. Refer to “Bezel Door” earlier in this chapter.
2. Slide the hard drive release latch (1) to open the ejector lever (2).
3. Pull the hot-plug hard drive out of the drive bay.
1
2
Figure 2-18: Removing a hot-plug hard drive
To replace a hot-plug hard drive, push the drive back into the bay and then close the ejector
lever to fully seat the drive.