Filter
Top Products
Compaq FTAM Responder Diagnostic Messages
OSI/FTAM Responder Manual—425199-001
A-5
Protocol and Supporting Service-Related Diagnostic
Messages
1001
Cause. A request contained a parameter value that the Compaq FTAM responder did
not support: for example, the override parameter did not equal one of the values
supported by the Compaq responder, the maximum-string-length value was not in the
range expected by the Compaq responder or was not specified (the ISO FTAM default,
unbounded, is not supported by the Compaq responder), or the protocol version
specified in the initialize request was not version 1.
Effect. The responder does not perform the requested operation.
Recovery. The application or FTAM user should retry the request providing parameter
values that the responder supports. For information about parameters that the Compaq
FTAM responder supports, see Section 4.
1002
Cause. The responder received a request PDU that did not contain all the required
parameters, or the request was malformed. Any request PDU that has mandatory
parameters can cause the responder to return this diagnostic message.
Effect. The responder aborts the association.
Recovery. The application or FTAM user should retry the request with all mandatory
parameters. To determine which parameters are mandatory, refer to the FTAM PDU
definitions for FTAM in ISO 8571-4.
1007
Cause. The responder detected a protocol error. One possible error on a write is a data
value that does not conform to the maximum-string-length value established for the file.
Effect. The responder aborts the association. If the protocol error threshold (a value set
via the THRESHOLD attribute during responder configuration) has been exceeded, the
responder generates a protocol-error-threshold event (event number 22). If the problem
was an attempt to write a data value that does not conform to the maximum-string-
length value for the file, the Further Details field contains the message string length
violates the MSL.
Recovery. This can be an interoperability problem. Verify that the initiator is issuing a
valid request to the responder. The Compaq problem solver can do this by tracing the
responder and verifying the protocol. For information on tracing, refer to the SCF
Reference Manual for FTAM and APLMGR and the OSI/FTAM Configuration and
Management Manual.
Unsupported parameter values
Mandatory parameter not set
Unspecific FTAM protocol error