Filter
Top Products
Compaq FTAM Responder Diagnostic Messages
OSI/FTAM Responder Manual—425199-001
A-12
Selection-Related Diagnostic Messages
Effect. The service fails.
Recovery. The application programmer or FTAM user should check the attribute values
and determine which attribute the responder does not support, and then retry the request
without specifying the unsupported attribute in the create request. If the problem
persists, the Compaq problem solver can use the SCF TRACE command and the PTrace
utility to troubleshoot the problem. For more information on tracing and
troubleshooting, refer to the OSI/FTAM Configuration and Management Manual.
3004
Cause. A file has ceased to exist after being selected. The VFS has received an
operating system error 11 in attempting to access a previously selected file.
Effect. The service fails.
Recovery. The application or FTAM user should either retry the operation specifying a
file that exists, or try again after the Compaq problem solver has replaced the file.
3005
Cause. A create request has been sent with the override parameter set so that file
creation fails if the file already exists, and the file already exists in the file system. The
CREATE procedure returns an error indicating that the file already exists and cannot be
created.
Effect. The service fails.
Recovery. The application or FTAM user should purge the file before attempting to
create it, or change the override parameter in the create request to any valid value other
than the one specifying that file creation fails if the file already exists.
3006
Cause. The application or FTAM user attempted to create a directory list (NBS-9), the
CREATE procedure has failed to create a file, or one or more of the contents-type
parameters specified in the create request is not supported on the responder (for
example, the application or FTAM user might have specified a string-significance value
that is invalid for the document type).
Effect. The file is not created. The Further Details field identifies the related file-
system error number.
Recovery. For an interpretation of the file-system error number, refer to the Compaq
Guardian Procedure Errors and Messages Manual.
Non-existent file
File already exists
File cannot be created