Filter
Top Products
uSign User Manual
Table of Contents
1.0 Introduction.................................................................................................6
2.0 Features .....................................................................................................6
3.0 Model Designations ....................................................................................7
4.0 Installing uSign ...........................................................................................7
4.1 Communication Interface ........................................................................8
4.2 USB-CDC Setup ...................................................................................10
5.0 Terms & Abbreviations ...............................................................................7
6.0 Specifications ...........................................................................................10
6.1 Power requirement................................................................................10
6.2 Physical housing uSign 100 ..................................................................10
6.3 Physical housing uSign 200 ..................................................................11
6.4 LCD screen & Resistive touch pad .......................................................11
6.5 Communication interface ......................................................................11
6.6 LED.......................................................................................................11
6.7 Agency Approvals .................................................................................11
6.8 Electronics MTBF..................................................................................11
6.9 Electro-Static Discharges (ESD) ...........................................................11
6.10 Environmental .......................................................................................11
7.0 uSign commands description....................................................................13
7.1 Command protocol:...............................................................................13
7.2 System Commands...............................................................................13
7.2.1 Get firmware version......................................................................13
7.2.2 Get serial number ..........................................................................13
7.2.3 Get clip area ..................................................................................13
7.2.4 Set clip area...................................................................................13
7.2.5 Clear clip area................................................................................13
7.3 One byte commands.............................................................................14
7.3.1 Stop Capturing...............................................................................14
7.3.2 Start Capturing use FBP format 1..................................................14
7.3.3 Start Capturing use FBP format 2..................................................14
7.3.4 Turn red led on ..............................................................................14
7.3.5 Turn red led off ..............................................................................14
7.3.6 Clear CMP format mode data ........................................................14
7.3.7 Get data 0x00 ................................................................................14
7.3.8 Start Capturing use CMP format....................................................14
7.3.9 Reset points counter......................................................................14
7.3.10 Get point counter high byte............................................................14
7.3.11 Get point counter low byte .............................................................14
7.3.12 Start Capturing use FBP format 0..................................................15
7.4 Multi-byte commands............................................................................15
7.4.1 Initialize device ..............................................................................15
7.4.2 Get PW120 Version .......................................................................15
7.4.3 Test device ....................................................................................15
7.4.4 Set CTS control .............................................................................15
7.4.5 Set interval between two points .....................................................15
Copyright © 2006, International Technologies & Systems Corp. All rights reserved.
Page 4 of 18