Filter
Top Products
Chapter 2 - Mounting Instructions 7
Installing Mounting Ears and Handles
Figure 2. Installing Mounting Ears and Handles for a Standard Equipment Rack
Figure 2.1. Installing Mounting Ears for a Telco Rack
The mounting ears should be installed on the IntraPort Enterprise-8 VPN Access Server
whether you are planning to rack-mount it or not. The handles need not be installed for Telco
rack mounts because there is not enough finger room to use them, but the handles are recom-
mended for all other installations.
If you are not going to rack-mount the IntraPort Enterprise-8, it is recommended that you
install the mounting ears and handles using the Standard Equipment Rack position (as shown
in Figure 2).
1. Use the supplied screws and fasten the mounting ears to the sides of the device using
5 screws on each side as shown in Figure 2 (for a standard equipment rack) or in Fig-
ure 2.1 (for a Telco rack).
2. Use the supplied screws and fasten the handles and spacers to the center of the mount-
ing ears as shown in Figure 2.