Filter
Top Products
Chapter 8 - LED Patterns and Test Switch Settings 30
Chapter 8 - LED Patterns and Test Switch Settings
IntraPort Enterprise-8 LED Patterns
The IntraPort Enterprise-8 VPN Access Server uses a number of light patterns on its front LED
bars to indicate operating conditions.
v Note: Any continuous flashing pattern not noted in this chapter may be caused by a hard-
ware failure. Please call Compatible Systems’ Technical Support if your server shows a hard-
ware failure.
Over Temp
The server is above the proper operating temperature. The filter needs changing. See
Appendix E for instructions.
Sys Ready
The server booted properly without detecting any failures.
General Indicators
Ethernet Traffic Indicators
TX: Ethernet transmit packet
RX: Ethernet receive packet
Load % Indicators
These lights indicate the load on the encryption coprocessor card.
Ethernet Lights Load Lights Indication
5 flashing 20 flashing Server stacks starting up.
3&4 flashing 40&60 flashing No OS loaded. Running from ROM.
1&4 flashing 40&100 flashing Erasing OS in Flash ROM.
5 flashing 20,40&60 flashing Erasing config in Flash ROM.
Scanning from the outside toward the center Flash ROM erase due to switch setting five or six is
complete. Set switch to zero and cycle power.