Filter
Top Products
Page 95
Enable Parallel Broadband
Begin by verifying that every access point in the network is properly
configured to connect to its individual broadband Internet account.
Secondly ensure that either:
• each access point is connected to an Ethernet port in the network
OR
• the access points are wired to each other.
Then all the access points has to have the DHCP server, followed by the
Parallel Broadband feature, enabled through the web-based
configuration. Please note that all the access points need to be
interconnected.
Step 1:
Select Parallel Broadband from the CONFIGURATION command menu.
Step 2:
Select Enable and click the Apply
button.
Step 3:
Repeat Step 1 and Step 2 for the rest of
the access points.
New users will then be assigned to the
access point with the smallest load,
ensuring that each access point has
approximately the same number of
users.
Important:
Implementing Parallel Broadband is redundant if
there is only 1 access point.