Filter
Top Products
Page 170
Channel
SYNTAX DESCRIPTION
Set channel <value> (Value in decimal)
SSID
SYNTAX DESCRIPTION
Set ssid <string> (Not More than 32 characters)
Closed System
SYNTAX DESCRIPTION
Set hidessid enable/disable Enable or disable broadcasting of SSID.
Per Node
SYNTAX DESCRIPTION
Set apbridge enable/disable Enable or disable isolation of wireless client.
RTS, Fragment, and Beacon Interval
SYNTAX DESCRIPTION
Set rts <value (Value in decimal, default 2312, range 1 to 2312)
Set fragment <value> (Value in decimal, default 2346, range, 256 to 2346)
Set beaconintval <value> (Value in decimal, default 1, range 1 to 1000)
Set dtim <value> Data Beacon Rate (value in decimal, default 1, range 1 to 16384)
WLAN State
SYNTAX DESCRIPTION
Get wlanstate Display whether status of current wireless operation is Enabled or Disabled.
Set wlanstate enable/disable Set to Disable to turn off wireless operation.
Set to Enable to turn back on wireless operation.
Note:
When executing this command, please ensure that you are not connected on
wireless with device or you will be disconnected from the device and network.
The wireless operation can only be Enabled from the Ethernet port or UTP cable
connection to device.
Reset Button
SYNTAX DESCRIPTION
Get buttonpassreset Display the status of Reset Button operation.
If status is (Enabled), resetting of password by pressing Reset Button is allowed.
If status is (Disabled), resetting of password by pressing Reset Button is not allowed.
Set buttonpassreset enable/disable Set to Disable to prevent resetting of password by pressing Reset button.
Set to Enable to allow resetting of password by pressing Reset button.
Upgrade Firmware
SYNTAX Set upgrade <IP address of AP> <firmware image filename>
DESCRIPTION To upgrade firmware in CLI enter this command with the IP address of AP and the
firmware image filename.