Filter
Top Products
- 17 -
• Network. Will vary according to the type of card - could be coaxial cable
(BNC) or twisted-pair (RJ-45).
6. Connect one end of the monitor power cord to the monitor and the other end to a
surge suppressor.
7. Connect one end of the system power cord to the system and the other end to a
surge suppressor. Make sure the power supply’s voltage selector is set to 115V and
the emergency switch is pressed down to the negative (-) symbol.
8. Before you turn your computer on, be sure to read and accept the license
agreements for your operating system. These are usually found on the diskette or
CD-ROM packaging. Turn on your computer and monitor using the Power buttons on
the front of the respective units.
Congratulations!
Welcome to the world of high performance CTL computing! If your system does not start up
properly, please review “Identifying Ports” and “Making Connections,” found earlier in this
chapter, or consult Chapter 5, “Troubleshooting.”