Filter
Top Products
BlueStorm Installation Guide, Connect Tech Inc.
Revision 0.10 11
)Figure 6: BlueStorm/SP RJ-11 (8 Port Model)
Note: Refer to Table 8 for port 7 and port 8 pinouts.
Jumper Configuration for BlueStorm
Jumper configuration options will vary by model. BlueStorm/LP RS-422/485 cards feature the
jumper layout listed in Figure 7, while BlueStorm/SP and BlueStorm/SP Opto cards use the
jumper layout in Figure 8. Lastly, BlueStorm/SP RJ-11 uses the jumper layout used in Figure 9.
BlueStorm ports and cards that communicate only in RS-232 modes do not have jumper blocks
installed.
Figure 7 demonstrates a common set of jumper configurations for a BlueStorm/LP RS-422/485
card. BlueStorm/LP RS-232 ports do not require jumper configuration. The four RS-422/485
ports are set as follows: Port 1 is set for half duplex, Port 2 is set for half duplex, Port 3 is set for
full duplex and Port 4 is set for multi-drop slave.
Figure 8 indicates a common set of jumper configurations for BlueStorm/SP and BlueStorm/SP
Opto. The four ports are set as follows: Port 1 is set for RS-232, Port 2 is set for half duplex,
Port 3 is set for full duplex and Port 4 is set for multi-drop slave.
6 x RJ-11
Pin 1 Pin 1