Filter
Top Products
CHAPTER 6 - RAID Controller
SPI-8450-LLVA
53
Installing Drivers With Existing Windows 98SE system
The following three sections detail the installation of drives on a system that has Windows
98SE installation.
1. After installing and configuring your RAID hard drive(s), power up the system and boot
Windows.
2. The “Add New Hardware Wizard” will appear, informing you that it has found a “PCI
RAID Controller.”
3. Check the “Search for the best driver for your device” box and click the Next button.
4. Check the “Specify a Location” box and click Next button.
5. Type “D:RAID\Win9x-ME” in the box that appears.
* This case the CD-ROM drive is D: .
6. Insert the CD-ROM in drive D: .
7. Click on “Next”. The add new hardware wizard will say it has found “Wind9x-ME
Promise FastTrak100-Lite controller”.
8. Click on “Next”, and then on “Finish”.
9. Choose “Yes” when asked if you want to restart your computer. Be sure to eject the CD-
ROM from drive D:.
Confirming Windows 98 Installation
To confirm that the driver has been properly loaded in Windows98, perform the following
steps:
1. Choose “Settings” from the “Start” menu.
2. Choose “Control Panel,” and then double-click on the “System” icon.
3. Choose the “Device Manager” tab, and then click the “+” in front of “SCSI &RAID
cntrollers.” “Win9X-ME FastTrak100-Lite controller” should appear.