Filter
Top Products
ISYS
®
TILT TOUCHPANELS
Isys
®
Tilt Touchpanel Accessories
www.crestron.com | 800.237.2041 | 201.767.3400
© 2007 Specifications subject to change without notice
tilt touchpanels
SWIVEL BASES AND HATCHBACK
HBK-3000 Hatchback for Isys
®
6.4" and 10.4" Tilt Touchpanels
The HBK-3000 hatchback is an optional rear
cover accessory for Isys TPS-3000 and TPS-6000
tilt touchpanels. The hatchback is designed
to conceal the connections at the back of the
touchpanel base, preventing disconnection
and providing cable strain relief.
57
SMK-3000 Swivel Mount for Isys
®
6.4" and 10.4" Tilt Touchpanels
The SMK-3000 swivel mount is an optional mounting
accessory for Isys TPS-3000 and TPS-4000 tilt
touchpanels. The swivel mount provides a means
of permanently mounting the touchpanel base to a
flat countertop or tabletop surface* while still allowing
for optimal positioning with 330-degree rotation.
Once installed, the swivel mount may be locked
in position if desired.
The swivel mount kit includes an HBK-3000
hatchback to conceal the connections at the back
of the touchpanel base. Cables may be passed out
the back of the cover, or ideally routed down through
the center of the swivel mechanism for a completely
hidden solution.
*Surface thickness must be 3/4-inch minimum to 1 3/8-inches
maximum using the hardware provided.
SMK-12/15/17 Swivel Mount for Isys
®
12", 15", and 17" Tilt Touchpanels
The SMK-12/15/17 swivel mount is an optional
mounting accessory for new Isys 12, 15, and 17 inch
tilt touchpanels including TPS, TPS-G, and TPMC
series. The swivel mount provides a means of
permanently mounting the touchpanel base to a flat
countertop or tabletop surface* while still allowing for
optimal positioning with 330-degree rotation. Cables
may be passed out the back of the touchpanel,
or routed down through the center of the swivel
mechanism** for a completely hidden solution.
*Surface thickness must be 3/4-inch minimum to 1 3/8-inches
maximum using the hardware provided.
**The touchpanel must include a notch at the rear of the bottom
plate to allow for cable pass-thru.