CyberPower Systems PR1500 Power Supply User Manual


 
1
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment
into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer
or an experienced radio/TV technician for help. Any special accessories needed for compliance must
be specified in the instruction.
CAUTION: A shielded-type power cord is required in order to meet FCC emission limits and also to
prevent interference to the nearby radio and television reception. It is essential that only the supplied
power cord be used. Use only shielded cables to connect I/O devices to this equipment.
CAUTION: Any changes or modifications not expressly approved by the guarantee of this device could
void the user’s authority to operate the equipment.
For more information, contact us at:
CyberPower Systems (USA), Inc.
5555 12
th
Avenue East, Suite 110
Shakopee, MN55379
Tel: (952) 403-9500
Fax: (952) 403-9500
Email: sales@cyberpowersystems.com
Web: www.cyberpowersystems.com
Entire contents copyright ©2003 CyberPower Systems, Inc.
All rights reserved. Reproduction in whole or in part without permission is prohibited.
PowerPanel™ and PowerPanel Plus™ are trademarks of CyberPower Systems (USA), Inc.