Filter
Top Products
Operation Theorem • 25
4.2 Timer/Counter Operation
4.2.1 Introduction
One 8254 programmable timer/counter chip is installed in 48H/96H series.
There are three counters in one 8254 chip and 6 possible operation modes
for each counter. The block diagram of the timer/counter system is shown
in Figure 4.2.
Event IRQ
Counter #0
2 MHz Clock
Timer #1
Timer IRQ
Timer #2
8254 Chip
C
G
C
G
C
G
O
O
O
'H'
'H'
'H'
Trigger
Edge
Control
P1C4
Figure 4.2 Timer/counter system of 48H/96H series.
The timer #1 and timer #2 of the 8254 chip are cascaded as a 32-bit
programmable timer. In software library, the timer #1 and #2 are always
set as mode 2 (rate generator).
In software library, the counter #0 is used as an event counter, that is,
interrupt on terminal count of 8254 mode 0 . Please refer to chapter 5 for
programming the timer/counter functions.
4.2.2 General Purpose Timer/Counter
The counter 0 is a general purpose timer/counter for users applications. It
can be used as an event counter, or used for measuring frequency, or other
functions. The following Mode are provided by the 82C54 chip.
l Mode 0: Interrupt on Terminal Count
l Mode 1: Programmable One-Shot.
l Mode 2: Rate Generator.
l Mode 3: Square Wave Rate Generator.
l Mode 4: Software Triggered Strobe.
l Mode 5: Hardware Triggered Strobe.