Filter
Top Products
ADVANCE
CY14B108L, CY14B108N
Document Number: 001-45523 Rev. *A Page 10 of 20
AutoStore or Power Up RECALL
Parameters Description
CY14B108L/CY14B108N
Unit
Min Max
t
HRECALL
[14]
Power Up RECALL Duration 20 ms
t
STORE
[15]
STORE Cycle Duration 15 ms
V
SWITCH
Low Voltage Trigger Level 2.65 V
t
VCCRISE
VCC Rise Time 150 μs
Software Controlled STORE/RECALL Cycle
In the following table, the software controlled STORE/RECALL cycle parameters are listed
[16, 17]
.
Parameters Description
20ns 25ns 45ns
Unit
Min Max Min Max Min Max
t
RC
STORE/RECALL Initiation Cycle Time 20 25 45 ns
t
AS
Address Setup Time 0 0 0 ns
t
CW
Clock Pulse Width 15 20 30 ns
t
GHAX
Address Hold Time 1 1 1 ns
t
RECALL
RECALL Duration 200 200 200 μs
t
SS
[18, 19]
Soft Sequence Processing Time 70 70 70 μs
Hardware STORE Cycle
Parameters Description
CY14B108L/CY14B108N
Unit
Min Max
t
DELAY
[20]
Time allowed to complete SRAM cycle 1 70 μs
t
HLHX
Hardware STORE pulse width 15 ns
Switching Waveforms
Figure 5. SRAM Read Cycle #1: Address Controlled
[10, 11, 21]
t
RC
t
AA
t
OHA
ADDRESS
DQ (DATA OUT)
DATA VALID
Notes
14.t
HRECALL
starts from the time V
CC
rises above V
SWITCH.
15.If an SRAM Write has not taken place since the last nonvolatile cycle, no STORE takes place.
16.The software sequence is clocked with CE
controlled or OE controlled reads.
17.The six consecutive addresses must be read in the order listed in the mode selection table. WE
must be HIGH during all six consecutive cycles.
18.This is the amount of time it takes to take action on a soft sequence command. Vcc power must remain HIGH to effectively register command.
19.Commands such as STORE and RECALL lock out IO until operation is complete which further increases this time. See the specific command
20.On a hardware STORE initiation, SRAM operation continues to be enabled for time t
DELAY
to allow read and write cycles to complete.
21.HSB
must remain HIGH during READ and WRITE cycles.
[+] Feedback