Filter
Top Products
CY7C1034DV33
Document Number: 001-08351 Rev. *C Page 5 of 9
Write Cycle
[9, 10]
t
WC
Write Cycle Time 10 ns
t
SCE
CE
Active LOW to Write End
[3]
7ns
t
AW
Address Setup to Write End 7 ns
t
HA
Address Hold from Write End 0 ns
t
SA
Address Setup to Write Start 0 ns
t
PWE
WE Pulse Width 7 ns
t
SD
Data Setup to Write End 5.5 ns
t
HD
Data Hold from Write End 0 ns
t
LZWE
WE HIGH to Low Z
[7]
3ns
t
HZWE
WE LOW to High Z
[7]
5ns
Data Retention Characteristics
Over the operating range
Parameter Description Conditions
[3]
Min Typ Max Unit
V
DR
V
CC
for Data Retention 2 V
I
CCDR
Data Retention Current9 V
CC
= 2V, CE
1
, CE
3
> V
CC
– 0.2V,
CE
2
< 0.2V, V
IN
> V
CC
– 0.2V or V
IN
< 0.2V
25 mA
t
CDR
[11]
Chip Deselect to Data Retention Time 0 ns
t
R
[12]
Operation Recovery Time t
RC
ns
Figure 3. Data Retention Waveform
AC Switching Characteristics (continued)
Over the operating range
[5]
Parameter Description
–10
Unit
Min Max
3.0V3.0V
t
CDR
V
DR
> 2V
DATA RETENTION MODE
t
R
CE
V
CC
Notes
9. The internal write time of the memory is defined by the overlap of CE
1
LOW, CE
2
HIGH, CE
3
LOW, and WE LOW. Chip enables must be active and WE must be LOW
to initiate a write and the transition of any of these signals terminates the write. The input data setup and hold timing are referenced to the leading edge of the signal
that terminates the write.
10.The minimum write cycle time for Write Cycle No. 3 (WE
controlled, OE LOW) is the sum of t
HZWE
and t
SD
.
11. Tested initially and after any design or process changes that may affect these parameters.
12.Full device operation requires linear V
CC
ramp from V
DR
to V
CC(min)
> 50 μs or stable at V
CC(min)
> 50 μs.
[+] Feedback