Filter
Top Products
page 3 MAN#650244:A
SPEED Speed gauge menu
UNIT Select unit for speed
Toggle between MPH and KPH (select unit to use for calibration)
AUTO Auto calibrate speed to a marked mile or kilometer
Pulls up all values on speed and speed pulses in odometer
Press Right switch to finish cal and save value
ADJUST Adjust speed cal while driving
ADJUST Each press of left switch toggles direction of adjustment, right switch to save and exit
SRV MI (SRV KM) Sets value of service odometer set when service odometer is reset
OFF ( OFF) Turns off the count down service odometer (default)
500 ( 800) Sets service to 500 mi or 800 km when resetting service odometer.
…. Service point can be set in 500 mi (800km) increments.
7500 (12000) Sets service to 7500 mi or 12000 km when resetting service odometer.
MAIN Returns to info menu
TACH Tachometer gauge menu
update Sets update rate for tachometer readout screen
SLOW tach updates at slowest rate (default)
MEDIUM
FAST fastest update on tach
WARN Sets RPM warning point (default 5500 RPM)
W 2250 Minimum warning point of 2250 RPM
…. Warning point can be set in 250 RPM increments
W 9750 Maximum warning point of 9750 RPM
SRV HR Sets service hour value used when resetting count down service hour meter
OFF Service hour meter disabled (default)
10 Minimum service hour set point
… Service hour reset point can be set in 10 hr increments
310 Maximum service hour set point
MAIN Returns to info menu
GAUGES Gauge option menu
VLT HI Set high voltage warning point (default 15.4V)
VLT LO Set low voltage warning point (default 11.1 V)
OIL LO Set low oil pressure warning point (default 9 PSI)
WTR HI Set high water temp warning point and set temperature unit (default 251F)
DEG F (DEG C) Select temp unit, press left switch to change, right switch to save
WTR HI Select high warning, left switch to change, right switch to save
MAIN Returns to info menu
OPTION Option menu
DIM LV Adjust dimming point on gauge
OFF Dimming function is off
LVL 1 Gauge will dim when light on gauge face is very low (default)
… 7 selectable dimming levels
LVL 7 Gauge will dim early when more light is on gauge face
DM OUT Enables/disables dim output for other gauges
ON Dim output will be high when gauge is dimming
OFF Dim output will be disabled (default)
WN OUT Selects which gauges provide a warn out signal on warn out wire (default all on)
WN OUT Gauges that provide signal out are lit up, left switch to change, right switch to save
NO WRN Warn output wire is disabled
CLOCK± Adjust clock speed for accuracy
-7 SEC Subtract 7 seconds from clock every 24 hrs
…
0 SEC No adjustment to factory clock speed (default)
…
+7 SEC Add seven seconds to clock every 24 hrs
St odo Allows presetting of odometer value on initial install (not available after 10 miles / 16km)
Set hr Allows presetting of hour meter value on initial install (not available after 1.0 hrs)
MAIN Returns to info menu
DONE Leaves setup menu if selected