Filter
Top Products
E-4203/E-4204/E-4304 51
Skips every other label
(Print quality is good, but every other label is skipped).
The label is formatted too close to the top edge of the label:
Leave white space equal to 8-dot rows (about .02 inch
[.5mm]) at the top of the label.
The media is not calibrated: Calibrate it (see Chapter 4).
If equipped, the Adjustable Media Sensor may need to be
repositioned (see Chapter 3).
The media sensor or media sensor circuitry may be
defective: Call for service.
Unable to print in rotation 4
The characters are formatted outside the dimensions of the
label: Check that the row/column values provide enough
room for the height of the image being printed.
Prints light on the right side of the label
The media width adjustment is set for a narrower media
width than is actually being used: Adjust for the media width
(see Chapter 5).
The printhead is not properly aligned: Call for service.
The printhead carrier assembly is not latched down: Latch it.
Printer fails to power on
The AC wall outlet may be faulty: Try another outlet.
A fuse may be blown: Call for service.
The power supply may be faulty: Replace it.
A defective power switch may exist on the printer: Call for
service.