Filter
Top Products
Back to Contents Page
Base Cover
Dell™Studio1535/1536/1537ServiceManual
Removing the Base Cover
1. Ensure that the computer is turned off.
2. Remove the battery (see Before Working Inside Your Computer).
3. Loosen the seven captive screws on the base cover and lift the cover off the computer at an angle as shown in the figure.
Replacing the Base Cover
1. Align the tabs on the base cover to the bottom of the computer.
2. Replace and tighten the seven captive screws on the base cover.
3. Slide the battery into the battery bay until it clicks into place.
Back to Contents Page
CAUTION: Before working inside your computer, follow the safety instructions that shipped with your computer.
CAUTION: Before performing this procedures, turn off the computer, disconnect the AC adapter from the electrical outlet and the computer,
disconnect the modem from the wall connector and the computer, and remove any other external cables from the computer.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
CAUTION: Do not touch the processor thermal-cooling assembly. Processor components should be removed only by trained support personnel.
1
base cover
2
captive screws (7)
3
tabs