Filter
Top Products
Back to Contents Page
Palm Rest
Dell™StudioXPS™1640ServiceManual
Removing the Palm Rest
Replacing the Palm Rest
Removing the Palm Rest
1. Follow the instructions in Before You Begin.
2. Remove the base cover (see Removing the Base Cover).
3. Remove the rear caps (see Removing the Rear Caps).
4. Remove the fourteen screws from the computer base.
5. Turn the computer over and remove the two screws from the top of the palm rest.
6. Lift the two tabs of the palm rest near the display.
7. Starting at the back center of the palm rest, use your fingers to gently ease the palm rest from the computer base by lifting the inside of the palm rest
while pulling on the outside.
8. Disconnect the keyboard cable and the touch pad cable from the respective system board connectors.
9. Lift the palm rest off the computer base.
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™isnot
covered by your warranty.
NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the
computer.
NOTICE: Carefully separate the palm rest from the computer base to avoid damage to the palm rest.