Filter
Top Products
Removing and Replacing Parts 4-9
4. If the drive is a SCSI drive, record the setting of the SCSI address
jumpers and SCSI bus termination jumper.
5. If present, remove the 50-pin to 68-pin adapter from the SCSI connec-
tor on the back of the drive.
Some drives use a 50-pin to 68-pin adapter between the SCSI cable and the
drive connector. Check the back of the drive for an adapter, if present,
remove it and retain it for use on the new drive.
Figure 4-7. Drive-Mounting Rails and Extensions Removal
When you reinstall a SCSI drive, set the SCSI address jumpers and the SCSI
bus termination jumpers to the settings you recorded.
drive-release
tabs
drive-mounting rails (2)
drive-mounting
extensions
50- to 68-pin
adapter