Filter
Top Products
Installing the Input/Output Panel
1. Insert the Input/Output panel into the slot on the chassis front.
2. Slide the Input/Output panel towards the right of the computer to secure to the chassis.
3. Tighten the single screw to secure the Input/Output panel to the chassis.
4. Thread the Input/Output panel or the FlyWire cable into the chassis clip.
5. Connect the Input/Output panel or the FlyWire cable to the system board.
6. Install the front bezel.
7. Install the cover.
8. Follow the procedures in After Working Inside Your Computer.
Related Links
Removing the Input/Output Panel
Removing The Power Supply
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Disconnect the power cables connected to the hard drive(s) and optical drive(s).
4. Unthread the power cables from the clips in the computer.
5. Disconnect the 24-pin power cable from the system board.
26