Filter
Top Products
1-10 Dell PowerEdge 4100/180 and 4100/200 Systems Service Manual
SCSI ID Numbers
Each device attached to the 7860 Ultra/Narrow SCSI host adapter must have a
unique SCSI ID number from 0 to 7. For additional SCSI addressing informa-
tion, see Chapter 10, “Installing Drives in the Internal Bays,” in the Installation
and Troubleshooting Guide.
When narrow SCSI devices are shipped from Dell, the default SCSI ID numbers
are assigned as follows:
• The computer’s built-in Ultra/Narrow SCSI host adapter is configured
through the BIOS as SCSI ID 7.
• A SCSI CD-ROM drive (installed in an externally accessible drive bay) is
configured as SCSI ID 5.
• A SCSI tape drive (if installed) is configured as SCSI ID 6.
NOTE: There is no requirement that SCSI ID numbers be assigned sequentially or
that devices be attached to the cable in order by ID number.
Devices attached to the Ultra/Wide SCSI host adapter need no ID settings or ter-
mination; ID settings and termination are handled automatically by the SCSI
backplane.
Device Termination
SCSI logic requires that termination be enabled for the two devices at opposite
ends of the SCSI chain and disabled for all devices in between. Therefore,
regardless of whether you are installing internal or external devices, use the fol-
lowing guidelines:
• A single SCSI device (such as the standard CD-ROM drive) is terminated.
• If two or more SCSI devices are installed, connect the devices as follows:
— Attach one of the devices to the end connector on the SCSI cable, and leave the
terminator enabled on that device.
— The other end of the SCSI cable connects to the computer’s built-in Ultra/Narrow
SCSI host adapter or to an optional SCSI host adapter card, which needs no
termination.
— Disable the terminators on all other devices you attach to the cable.
The standard SCSI CD-ROM drive is configured as the last device on the SCSI
cable. Therefore, any additional devices attached to the cable should have their
terminators disabled.
See the documentation provided with the SCSI device for information on dis-
abling the device’s terminator.