Filter
Top Products
Chapter 1 Installing the Battery Pack 7
Connecting Battery Packs
The PowerEdge Battery Backup Module usually is shipped with
an onboard four-cell Nickel- Metal Hydride battery pack already
installed. If this is the case, you must only insert the battery
connector into J2, as shown below. The battery cable connector is
keyed to make sure that the proper connection is made.
J2
Attach battery pack
connector to J2
American Megatrends, Inc. P/N: BAT-NIMH-4.8.01
CAUTION
ATTENTION
WARNING
Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
Il y a danger d'explosion s'il y a remplacement incorrect de la
batterie. Remplacer uniquement avec une batterie du meme]
type ou d'un type equivalent recommande par le constructeur.
Mettre au rebut les batteries usagees conformement aux
instructions du fabricant.
BEFORE ADDING OR REMOVING DRAM MODULE, DISCONNECT
BATTERY PACK FROM BATTERY BACKUP MODULE.
PROMARK YYWW IIZ9503MSO
Install PowerEdge Card Install the PowerEdge card in the computer. See the Dell
PowerEdge RAID Controller User’s Guide for complete
installation instructions.