Filter
Top Products
2 PowerEdge Battery Backup Module User’s Guide
Overview, Continued
Battery Backup Module The backup module is shown below. There are no
jumpers to set. There are only two connectors that attach this
daughtercard to the PowerEdge controller card. Two three-pin
connectors (J1 and J2) attach the primary onboard battery pack
and a secondary battery pack.
J6
J5
Front of board
Bottom of board
J2
American Megatrends, Inc.
P/N: BAT-NIMH-4.8.01
CAUTION
ATTENTION
WARNING
Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
Il y a danger d'explosion s'il y a remplacement incorrect de la
batterie. Remplacer uniquement avec une batterie du meme]
type ou d'un type equivalent recommande par le constructeur.
Mettre au rebut les batteries usagees conformement aux
instructions du fabricant.
BEFORE ADDING OR REMOVING DRAM MODULE, DISCONNECT
BATTERY PACK FROM BATTERY BACKUP MODULE.
PROMARK YYWW IIZ9503MSO