Filter
Top Products
4 Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Installation Information
2. In the customer kit, locate the I
2
C extension cable. (This cable has three
connectors: a 20-pin connector on one end and in the middle and a 10-pin
connector on the other end.)
3. Attach the 10-pin connector on the I
2
C extension cable to the 10-pin connector on
the 1 x 2 backplane.
4. Attach the 20-pin connector on the I
2
C extension cable to the 20-pin connector
on the system board.
5. Attach the loose end of the I
2
C cable, which was set aside, to the middle connec-
tor of the I
2
C extension cable.
6. Attach a four-wire power cable to the power connector on the 1 x 2 backplane.
NOTE: The four-wire power cable is the standard cable found on all systems and
provides power to peripherals; for example, for a CD-ROM drive or tape drive.
)LJXUH,QVWDOOLQJWKH,
&([WHQVLRQ&DEOH
10-pin connector on
1 x 2 backplane
I
2
C extension cable
hard-disk drive
SCSI backplane
I
2
C cable
20-pin connector
on system board
power connector