Filter
Top Products
support.dell.com Novell NetWare Support for Dell PowerVault 65xF Storage Systems 12-3
3. If the Select Host Adapter screen is displayed, press the up- or down-arrow key
to highlight the controller you want and press <Enter>.
The Controller screen is displayed with a list of options for the selected
controller.
4. Press the up- or down-arrow key to highlight Configuration settings and press
<Enter>.
The Configuration Settings screen is displayed.
5. Press the up- or down-arrow key to highlight Advanced Adapter Settings and
press <Enter>.
The Advanced Adapter Settings screen is displayed.
6. Press the up- or down-arrow key to highlight Luns per Target and press <Enter>.
The Luns per Target screen is displayed.
NOTE: You must set the range of the LUNs to the minimum range that applies to
the number of LUNs on the SP. Setting the LUNs per Target value to a higher
value affects the time required for the server to boot. The maximum supported
setting is 32. For larger numbers of LUNs, Dell recommends having at least
256 MB of random-access memory (RAM) in the server.
7. Type the desired value and press <Enter>.
The Advanced Adapter Settings screen is displayed, and the Luns per Target
value is set correctly.
8. Press <Esc> twice, select File—> Save Changes, and press <Enter>.
9. Repeat steps 1 through 8 for each installed adapter and for each server.
For instructions on updating the QLogic HBA BIOS and NVRAM, see Chapter 4,
”Installing the Host Bus Adapter in the Server.”
,QVWDOOLQJ4/RJLF'ULYHUVRQWKH1HW:DUH
6HUYHU
For instructions on installing the drivers for the QLogic HBA in your NetWare server,
see Chapter 4, ”Installing the Host Bus Adapter in the Server.”
,QVWDOOLQJ&RQILJXULQJDQG8QLQVWDOOLQJ
'DWD0DQDJHG1RGHIRU1HW:DUH
Data Managed Node for NetWare must be installed on one of the NetWare servers.