Filter
Top Products
Information Update 11
E0880 PS REDUNDANCY
LOST
Power supply redundancy has
been lost because a power supply
has been removed from the
system.
Reinstall the power supply
to restore redundancy.
E0D76 BP DRIVE n Faulty or improperly installed
hard drive or RAID controller.
See "Troubleshooting SCSI Hard
Drives," "Troubleshooting a RAID
Controller Card," and
"Troubleshooting the Integrated
RAID Controller" in your
Installation and Troubleshooting
Guide.
E0D76 1x2 Drive n The specified drive on the 1x2
backplane is faulty or improperly
installed, or the RAID controller
is faulty or improperly installed.
See "Troubleshooting SCSI Hard
Drives," "Troubleshooting a RAID
Controller Card," and
"Troubleshooting the Integrated
RAID Controller" in your
Installation and Troubleshooting
Guide.
E0D76 SCSI CONNECTOR SCSI cable is not connected. See "Troubleshooting SCSI Hard
Drives" in your Installation
and Troubleshooting Guide.
EB107 PROC BUS PERR
PROC INIT ERR
PROC PROTOCOL
ERR
Faulty or improperly installed
microprocessor or system board.
See "Troubleshooting the
Microprocessors" in your
Installation and Troubleshooting
Guide.
If the problem persists, see
"Getting Help" in your
Installation and Troubleshooting
Guide.
EB107 PROC MACHINE CHK Faulty or improperly installed
microprocessor or system board.
See "Troubleshooting the
Microprocessors" in your
Installation and Troubleshooting
Guide. If the problem persists,
see "Getting Help" in your
Installation and Troubleshooting
Guide.
EB107 PROC HOT Processor is out of acceptable
temperature range and has halted
operation.
See "Troubleshooting System
Cooling Problems" in your
Installation and Troubleshooting
Guide.
Table 1-3. LCD Status Messages (continued)
Line 1
Message
Line 2
Message
Causes Corrective Actions