Filter
Top Products
Protection technology is disabled.
On — Execute Disable Memory
Protection technology is enabled.
Power Management
AC Recovery
(Off default)
Specifies how the computer will behave
when AC power is restored after an AC
power loss.
Off — The system stays off after
AC power is restored.
On — The system powers on
after AC power is restored.
Last — The system returns to
the previous state after AC power
is restored.
Auto Power On
(Off default)
Disables or selects when to
automatically turn on the computer.
Off — Do not use the Auto
Power Time.
Everyday — Turn the computer
on every day at the time set in
Auto Power Time.
Weekdays — Turn the computer
on Monday through Friday at the
time set in Auto Power Time.
NOTE: This feature does not work if
you turn off your computer using a
power strip or surge protector.
Auto Power Time Specifies the time to automatically turn
on the computer.
Change the time to automatically turn
on the computer by pressing the up- or
down-arrow key to increase or decrease
the numbers, or type the numbers in
the appropriate time field.
NOTE: This feature does not work if
you turn off your computer using a
power strip or surge protector.
Low Power Mode
(Off default)
Specifies how aggressive the system is
at conserving power while in hibernate
mode or turned off.
Off — Add more functionality.
On — Conserve more power.
Suspend Mode
(S3 default)
Specifies the power management
suspend mode.
S1 — The computer resumes
more quickly from sleep mode.
S3 — The computer conserves
more power when not in use
(system memory remains
active).
Maintenance
Service Tag Displays the system service tag.
SERR Message
(On default)
Controls the SERR message
mechanism. Some graphics cards
require that the SERR Message
mechanism be disabled.
Off — Do not use the SERR
message mechanism.
On — Use the SERR message
mechanism.
Load Defaults This setting restores the computer's
factory-installed default settings.
Cancel — Do not restore factory-
installed default settings.
Continue — Restore factory-
installed default settings.
Event Log Displays the system event log.
Mark all entries — Mark all
event log entries as read (R).
Clear log — Clear all event log
entries.
NOTE: Once an event log entry is
marked as read (R) that entry cannot
Page
8
of
24
Documentation
6.07.2007
http://support.euro.dell.com/support/edocs/systems/720H2C/en/OM/appendix.htm