Filter
Top Products
Troubleshooting Your Projector 55
Image is out of focus 1
Adjust the focus ring on the projector lens.
2
Ensure that the projection screen is within
the required distance from the projector
(3.18 ft [97 cm] to 8.48 ft [258 cm]).
The image is stretched when
displaying a 16:9 DVD
The projector automatically detects the input
signal format. It will maintain the aspect ratio
of the projected image according to input
signal format with an Original setting.
If the image is still stretched, adjust the aspect
ratio in the Display Settings of the Advanced
Settings menu in the OSD.
Image is reversed Select Projector Settings of the Advanced
Settings from the OSD and adjust the
projector mode.
Error LED is blinking amber A projector fan has failed and the projector
will automatically shut down.
TEMP LED is solid amber The projector has overheated. The display
automatically shuts down. Turn the display on
again after the projector cools down. If the
problem persists, contact Dell™.
TEMP LED is blinking amber If the projector fan fails, the projector will
automatically shut down. Clear the projector
mode by pressing and holding the POWER
button for 10 seconds. Please wait for about 5
minutes and try to power up again. If the
problem persists, contact Dell™.
The OSD does not appear on
the screen
Press the Menu button on the panel for 15
seconds to unlock the OSD. Check the Menu
Lock on page 38.
The remote control is not
operating smoothly or works
only within a limited range
The battery may be low. Check if the LED
indication from the remote is too dim. If so,
replace with a new CR2032 battery.
Problem
(continued)
Possible Solution
(continued)