Filter
Top Products
Using Your Projector 29
3 To cancel the password function, select OFF and enter the password to
disable the function.
CHANGE PASSWORD—Allows you to change the password. Key in the original
password and then enter the new password. Enter the new password again to
confirm.
T
EST PATTERN—Select 1 or 2 to activate the built-in Test Pattern to test the focus
and resolution. Select Off to disable the function.
1
To run the diagnostics test pattern 1, press and hold the
Menu
button and
button on the projectors control panel simultaneously for two seconds.
2
To run the diagnostics test pattern 2, press and hold the
Menu
button and
button on the projectors control panel simultaneously for two seconds.
NOTE: To enable test pattern 2, it is required to connect an input signal to
projector.
F
ACTORY RESET —Select On to reset the projector to its factory default settings.