Dell NSA 4600 Network Router User Manual


 
Initial Setup | 15
This section provides initial configuration information and
instructions for connecting your Dell SonicWALL NSA 5600/
4600/3600 appliance. See the following sections:
Connecting the MGMT Port, page 15
Applying Power to the NSA 5600/4600/3600, page 15
NSA 5600/4600/3600 LED Activity, page 15
Using the Setup Wizard, page 16
Connecting the MGMT Port
1. Using the provided Ethernet cable, connect one end of the
cable to the computer you are using to manage the
Dell SonicWALL NSA appliance.
2. Connect the other end of the Ethernet cable to the MGMT
port on your Dell SonicWALL NSA appliance.
Applying Power to the NSA 5600/4600/3600
Connect the AC power cord from the Dell SonicWALL NSA
appliance into an appropriate power outlet.
For further information regarding power requirements, refer to
Product Safety and Regulatory Information, page 57 of this
document.
NSA 5600/4600/3600 LED Activity
The Power LEDs on the front panel illuminate blue when the
appliance is powered on.
The Test LED or Alarm LED may illuminate and blink while the
appliance performs a series of diagnostic tests. When these
LEDs are no longer illuminated and the Power LEDs remain
steadily lit, the Dell SonicWALL NSA 5600/4600/3600 appliance
is ready for configuration. This typically occurs within a few
minutes of connecting the power.
If the Test or Alarm LEDs remain lit after the NSA 5600/4600/
3600 has completed powering on, restart the appliance by
disconnecting the power, waiting 1 minute, then connecting the
power again.
For a connected MGMT or X0 - X11 port, the Link LED for the
port illuminates green or amber depending on the link
throughput speed, indicating an active connection:
Amber indicates 1 Gbps
Green indicates 100 Mbps
A unlit left LED with the right LED lit indicates 10 Mbps