Filter
Top Products
Installing the Input/Output (I/O) Board
1. Insert the I/O board into the chassis.
2. Connect the I/O board cable to the system board.
3. Install:
a. palmrest assembly
b. keyboard
c. memory module
d. hard drive
e. WLAN card
f. access panel
g. optical disk-drive
h. battery
4. Follow the procedures in After Working Inside Your computer.
Removing the Speakers
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. Battery.
b. optical disk-drive.
c. access panel.
d. hard drive.
e. memory module.
f. keyboard.
g. palmrest assembly.
3. Perform the following steps as shown in the illustration:
a. Disconnect the speaker cables from the system board [1].
b. Release the speaker cables from the retention tabs [2].
24