Filter
Top Products
Dell PowerConnect™ Firmware CLI Transition Guide
April 6, 2011 Page 19
Feature Previous Implementation Dell™ PowerConnect 4.x Implementation
Bridging bridge address
Interface Configuration mode
Rationale: The following parameters have been
deprecated:
delete-on-reset
delete-on-timeout
secure
DHCP and
BOOTP Relay
bootpdhcprelay
cidridoptmode
This command is changed to ip dhcp relay information
option.
DHCP and
BOOTP Relay
show bootpdhcprelay This command is changed to show ip dhcp relay
command.
DHCPv6 ipv6 dhcp relay-agent-info-
opt
This command is deprecated. Refer to the DHCPv6
Commands section in the CLI REFERENCE GUIDE.
DHCPv6 ipv6 dhcp relay-agent-info-
remote-id-subopt
This command is deprecated. Refer to the DHCPv6
Commands section in the CLI REFERENCE GUIDE.
DVMRP ip dvmrp trapflags The command is deprecated by the snmp-server enable
traps dvmrp command.
Ethernet
Configuration
Interface range ethernet This command is changed to interface range.
Ethernet
Configuration
negotiation This command is deprecated. Negotiation is now
configured using the speed or duplex commands. Refer
to the Ethernet Configuration Commands section in the
CLI REFERENCE GUIDE.
IGMP show ip igmp interface
membership groupaddr
[detail]
This command is changed to show ip igmp membership
[groupaddr] [detail] command.
IP Addressing ipv6 gateway This command is removed. Refer to the IP Addressing
Commands section in the CLI REFERENCE GUIDE.
IP Addressing show ip interface
management
This command is removed. Refer to the IP Addressing
Commands section in the CLI REFERENCE GUIDE.
IP Routing routing / no switchport This command is removed. Refer to the IP Routing
Commands section in the CLI REFERENCE GUIDE.
IP Routing show ip stats This command is changed to show ip traffic.
IPv6
Multicast
ipv6 pimsm and ipv6 pimdm These commands are replaced by the ipv6 pim
command.
IPv6
Multicast
ipv6 pimsm This command is replaced by ipv6 pim sparse (Global
config) and ipv6 pim dense commands.
IPv6
Multicast
ipv6 pimsm bsr-border This command is replaced by ipv6 pim bsr-border.
IPv6
Multicast
ipv6 pimsm bsr-candidate This command is replaced by ipv6 pim bsr-candidate.
IPv6
Multicast
ipv6 pimsm dr-priority This command is replaced by ipv6 pim dr-priority.
IPv6
Multicast
ipv6 pimsm hello-interval
and ipv6 pimdm hello-
interval
These commands are replaced by the ipv6 pim hello-
interval command.