Filter
Top Products
CAUTION: Take care not to damage the system identification button while placing the system board into the
chassis.
2. Hold the system board by its edges and angle it toward the back of the chassis.
3. Lower the system board into the chassis till the connectors at the back of the system board align with the slots on
the rear wall of the chassis, and the screw holes on the system board align with the standoffs on the chassis.
4. Install the nine screws that secure the system board to the chassis.
5. Replace the following:
a) internal dual SD module
b) heat sink/heat-sink blank and processor/processor blank
c) expansion-card risers
d) all expansion cards and the integrated storage controller card
e) cooling fan cables
f) memory modules
g) PDB shroud
h) cooling shroud
6. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed through the cable routing latch.
7. Close the system.
8. If applicable, install the front bezel.
9. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
10. Import your new or existing iDRAC Enterprise license. For more information, see the
iDRAC7 User's Guide
under
Software → Systems Management → Dell Remote Access Controllers,at dell.com/support/manuals.
102