Filter
Top Products
Item Indicator, Button, or
Connector
Icon Description
10 System identification button The identification buttons on the front and back panels
can be used to locate a particular system within a rack.
Hot-swappable
hard-drive
systems
When one of these buttons is
pressed, the LCD panel on the
front and the system status
indicator on the back flashes
until one of the buttons is
pressed again.
Cabled hard-drive
systems
When one of these buttons is
pressed, the system status
indicator on the back flashes
until one of the buttons is
pressed again.
Press to toggle the system ID on and off.
If the system stops responding during POST, press and
hold the system ID button for more than five seconds to
enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup) press
and hold the button for more than 15 seconds.
11 Power supply (PSU1) 350 W and 550 W
NOTE: For non-redundant power supply units, there is
only one power supply socket.
12 Power supply (PSU2)
NIC Indicator Codes
Figure 8. NIC Indicator
1. link indicator
2. activity indicator
Indicator Indicator Code
Link and activity
indicators are off
The NIC is not connected to the network.
Link indicator is
green
The NIC is connected to a valid network at its maximum port speed (1 Gbps or 10 Gbps).
18