Filter
Top Products
Using Your Projector 63
WIRELESS/LAN—Select On to activate the Wireless/LAN function. You
can also set the Wireless/LAN module to on/off while the projector is in the
standby status.
WIRELESS SETTINGS—Select and press to activate the Wireless Settings
menu. See "Wireless/LAN Settings (in Wireless Mode)" on page 64.
DHCP—If a DHCP server exists in the network to which the projector is
connected, the IP address will automatically be acquired when you select
DHCP On. If DHCP is Off, manually set the IP Address, Subnet Mask,
and Gateway. Use and to select the number of IP address, Subnet
Mask, and Gateway. Key in enter to confirm each number and then use
and to set the next item.
IP ADDRESS—Automatically or manually assigns the IP address to the
projector connected to the network.
SUBNET MASK—Configure the Subnet Mask of the network connection.
GATEWAY—Check the Gateway address with your network/system
administrator if you configure it manually.
DNS—Check the DNS Server IP address with your network/system
administrator if you configure it manually.
STORE—Press to save the changes made in network configuration
settings.
NOTE:
1. Use and button to select IP Address, Subnet Mask,
Gateway, DNS, and Store.
2. Press the button to enter IP Address, Subnet Mask, Gateway or
DNS to set the value. (The selected option is highlighted in blue)
a Use and button to select the option.
b Use and button to set the value.
c After the setup is complete, press the button to exit.
3. After the IP Address, Subnet Mask, Gateway, and DNS is set up,
select Store and press button to store the settings.