Filter
Top Products
A-12 Dell Dimension XPS H233 System Reference Guide
Found Plug and Play
ISA card:
Plug and Play
ISA Card Name
.
This message appears at sys-
tem boot for each Plug and
Play ISA card recognized by
the Configuration Manager.
Status message; no action is required.
NOTICE: Boot Device
Not Active! CSN=
Card
Select Number
.
A boot device was found to
be inactive.
Status message; no action is required. The Con-
figuration Manager automatically configures
and activates the device.
One or more active
devices have been
reconfigured -- system
requires reboot. Press
any key to reboot sys-
tem.
You modified the resource
values of one or more PCI or
Plug and Play ISA cards.
Reboot the system to reconfigure the card(s).
The Plug and Play ISA
card has been success-
fully configured.
Card Count
Plug and
Play ISA cards have
been successfully con-
figured.
The Configuration Manager
has successfully configured
the given number of cards.
If this message does not match the number of
Plug and Play ISA expansion cards installed in
your system, reinstall any Plug and Play cards
not listed and reboot the system.
WARNING: Boot Device
conflict detected!
CSN=
Card Select Number
Error=
Error
.
One of the devices is attempt-
ing to use one or more
resources assigned to the sys-
tem’s boot device.
Perform the following procedure:
1. Start the ISA Configuration Utility.
2. Identify the card marked “
config
err
.”
This should be the card that is attempting to
use one or more resources required by the
system’s boot device.
3. Go to the procedures provided for the
last error message in this table.
Table A-4. Configuration Manager Messages
(continued)
Message Probable Cause Corrective Action
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online
System User’s Guide
.