Filter
Top Products
Back to Contents Page
Ultra Wide Band (UWB) Card
Dell™Latitude™Z600ServiceManual
Removing the UWB Card
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery from the computer.
3. Remove the hinge covers from the computer.
4. Remove the access panel from the computer.
5. Disconnect the antenna from the UWB card.
8. Remove the screws that secure the UWB card to the system board.
9. Remove the UWB card from the computer.
Replacing the UWB Card
To replace the UWB, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.