Filter
Top Products
-2-
598-1126-00
5. Mount push button and chime.
Use either a screw or double sided tape to mount push button.
To mount with screw, determine where push button will be located. Using 3/
16" drill bit, drill tap hole. If screw is not mounted directly into wood stud or
trim molding, use drywall anchor. Insert screw leaving approximately 1/8"
gap between head of screw and wall. Place keyhole slot on rear of push
button over the screw’s head and slide down firmly.
When attaching push button using double sided tape, make sure the surface
is clean.
Chime can be mounted by using 1 screw with keyhole (see illustration on
page 1) or placed on top of a desk or table. Follow steps under mounting
push button with screw to mount chime.
Temporarily position chime and push button where you want them mounted.
Press push button to verify chime and push button work properly. If chime
does not sound, see
Troubleshooting
.
3. Test functions.
4. Adjust volume.
The chime is equipped with a High/Low switch located on the left side. Slide
the switch to either High or Low to adjust volume.
Before returning product to store, please see
Troubleshooting
section
or call Technical Service toll free: 1-800-858-8501.
STOP