Desa 1204 Computer Monitor User Manual


 
-4-
598-1126-00
Chime Tune Settings
Your wireless chime has different selectable tune modes: 4 prerecorded
sounds and 1 setting that cycles through the 4 prerecorded sounds (model
1204 adds the ability to record up to 10 seconds of audio via the audio cable
or built-in microphone, see instructions below).
To select different tune modes, slide switch located on right side of chime to
numbers 1 through 4 to select the prerecorded sound desired. Select “All” to
allow chime to cycle through the 4 prerecorded sounds each time the chime
sounds.
Model 1204: To record up to 10 seconds of audio using the audio cable, plug
one end of the audio cable into the 3
1
/
2
mm headphone or audio out jack on
your sound source. Plug other end of audio cable into 3
1
/
2
mm audio jack
located on back of chime near the top. Slide tune setting switch to position
number 5. Push down and hold “Rec” button (located near audio jack) while
playing audio from your sound source. Release “Rec” button when completed.
To record up to 10 seconds of audio using built-in microphone, press down
and hold the “Rec” button located on the back of the chime near the top while
speaking or playing the audio from your sound source. Release the “Rec” but-
ton when completed.
Note:
The microphone is located on front of chime. For
best results, do not hold the microphone closer than 2" to the sound source.
Recording Push Button Audio
Your push button has the capability to record up to 10 seconds of audio for
personalized messages and sounds.
All Models: To record up to 10 seconds of audio, press down and hold “Rec”
button located on back of push button near bottom while speaking or playing
audio from your sound source. Release “Rec” button when completed.
Note:
The microphone is located on front of push button. For best results, do not
hold the microphone closer than 2" to the sound source.
Model 1204: To record up to 10 seconds of audio, plug one end of the audio
cable into the 3
1
/
2
mm headphone or audio out jack on your sound source.
Plug other end of audio cable into 3
1
/
2
mm audio jack located on back of
push button near the bottom. Push down and hold “Rec” button (located near
audio jack) while playing audio from your sound source. Release “Rec” but-
ton when completed.
Before returning product to store, please see
Troubleshooting
section
or call Technical Service toll free: 1-800-858-8501.
STOP