Filter
Top Products
IP POWER 9258 USER MANUAL
* Http Command Verification : setup the control possibility from HTTP command or SDK
(VB & VC)
1. Select “ Cookie +Base64 “ : enable Http command & SDK control
2. Select “ Cookie “ : enable Http command & SDK control
2-1 IP address Settings: Ethernet (LAN ) and Internet(WAN)
2-1-1 Local Area Network (LAN) :
In LAN, you can set a fixed IP address or gain it from a DHCP server automatically. We
suggest to use a fixed IP address in order to let the other computers can visit the 9258.
Now type the new IP address in the address field of IE, you can visit the 9258. You also can
use the ipedit.exe to find the IP Power 9258 and modify its IP address.
2-1-2 Work on Internet (WAN) :
User can set the IP provided by your ISP. If the IP Power 9258 has a public IP address,
you can control it through the Internet. IP Sensor 9258 supports fixed IP, DHCP.
* IP Address: please type in the IP address provided by your ISP. If IP Power 9258 is
working with a Router, please refer to the network settings of the Router.
* Subnet Mask : please type in the Subnet Mask provided by your ISP. If IP Power 9258 is
working with a Router, please refer to the network settings of the Router.
* Default gateway: please type in the Default Gateway provided by your ISP. If IP Power
9258 is working with a Router, please refer to the network settings of the
Router.
* DNS Server : please fill in the IP address of DNS server. If you are in Taiwan, you can set
it to 168.95.1.1.
* DHCP Clients: Enable– activate DHCP service. DHCP will assign IP address for each PC.
Disable – shut down the DHCP service. You can set the IP address by
yourself.
* Beeper : Enable – activate the beeper . Disable – turn off the beeper.
If you control the 9258 through the web page, the beeper will beep once
when the operation work.
NOTICE:
1) IP address format : xxx.xxx.xxx.xxx: yyyyy. yyyy means the port number,
Ranging from 1 to 32767.
2) Subnet Mask: from 0 to 254 ( xxx.xxx.xxx.0 ~ xxx.xxx.xxx.254 )
3) If DHCP is disabled, user must set the TCP Port and default Gateway .If DHCP is
enabled, then the TCP port will be preset to 80( xxx.xxx.xxx.xxx: 80 ) and the
default gateway will be set by the DHCP server, too..
4) If the TCP port you set is not 80, your should type in the whole IP address and port in
IE or Netscape, such as
http://xxx.xxx.xxx.xxx:yyyyy , or you can use the ipedit.exe
to login into the virtual IP of IP Power 9258.
- 12 -