IMG 1004 Quick Start Guide
Dialogic Corporation Part # 07-8724-00 Page 4 of 7
Quick Start Guide Overview - IMG 1004
Topic Location: IMG1004-Quick Start Guide
Overview
This IMG 1004 Quick Start Guide is an abbreviated guide which explains how to connect power and network cabling. For
more information on setup please either refer to the “IMG 1004-Installation and Setup Guide” on the Technical Publications
CD supplied or go to the Dialogic Technical Support website at http://www.dialogic.com/support for detailed information on
installing and setting up the IMG 1004 and Dialogic GCEMS.
NOTE: To access the Dialogic Technical Support website, you will need a username and password. To obtain a username
and password, you will need a support contract with Dialogic. Once a support contract is obtained a username and password
will be supplied via email.
Shipping Information
Review the packing list to check that all the items listed on the packing list have been sent. Should any discrepancies exist,
contact your Dialogic Representative immediately.
Connecting AC Power
Power Specifications
The AC input power must conform to the specifications in the table below. Insert one end of AC cord into rear of IMG 1004
and the other end into a grounded wall outlet, uninterruptible power supply (UPS), or surge protector.
AC Operating Range
Power 120 – 240 VAC / 1.5 - 3 Amps 90 – 240 VAC
Frequency 50 or 60 Hz 50-60 Hz
AC Power Module
The IMG 1004 provides an AC input power module with an integrated fuse, power switch, and standard three position female
AC input connector. This connector allows the IMG 1004 to interface with all variations of AC outlets by simply using a
standard power cable and compatible outlet plug.
Configuring Linux on GCEMS server
IMPORTANT: Please read and understand the IMG 1004 technical documentation prior to performing any setup or
installation procedures. The documentation can be accessed at: http://www.dialogic.com/support
If the IMG 1004 was purchased with the GCEMS Server then the Linux Red Hat Operating System
and GCEMS application have already been installed. Downloading System Software to the IMG 1004
will be the next step to getting the IMG 1004 configured. See topics under the following heading.
IMG 1004-Installation and Setup Guide > IMG 1004-Software Installation and Setup
If server was not purchased, then one must be configured with Red Hat Enterprise Linux. The IMG
1004 supports Red Hat Enterprise Linux 3, Red Hat Enterprise Linux 4 and Red Hat Enterprise Linux
5. Refer to the individual topics located under each of the following headings in the Online
Documentation for more information on configuring the Linux Server.
IMG 1004-Installation and Setup Guide > IMG 1004-Linux Red Hat Installation
IMG 1004-Installation and Setup Guide > IMG 1004-Software Installation and Setup
IMG 1004-Installation and Setup Guide > IMG 1004-SD Card
Configuring Services on GCEMS Server