Dialogic IMG 1004 Network Card User Manual


 
IMG 1004 Quick Start Guide
Dialogic Corporation Part # 07-8724-00 Page 7 of 7
SS7 links are brought in over the Bearer Ports
Starting ClientView to start Configuring Switch
Once the IMG 1004 has software installed, the cabling is connected, and the GCEMS server has been configured then the
ClientView application can be used to configure the IMG 1004. Below are a few topics from Online documentation to get you
started on configuring the IMG 1004 through the ClientView GUI
Configuration > ClientView > (All topics under this book)
Configuration > Introduction
Configuration > Node Configuration Wizard
Configuration > Basic Configuration
From here you are ready to configure the IMG 1004 for your network. Use the Online Manual Configuration, Clientview, and
ClientView Pane sections to configure the IMG 1004.